Skip to main content

AI AC Capacity Estimator

Describe the room (“20 m² bedroom, average insulation, sunny afternoon sun, 3 occupants”). The estimator applies the standard rule-of-thumb load factors — baseline per square meter, adjustments for insulation quality, sun exposure, occupants, kitchen transfer and ceiling height — and reports the estimated capacity in BTU/h and kW. It is a sizing pre-estimate for shopping guidance, not a replacement for a Manual-J / proper heat-load calculation.

Ask in plain words

The AI reads your question and fills in the parameters; a verified calculator engine does every calculation.

How to use the AI AC Capacity Estimator

  1. Measure the floor area of the space (length × width).
  2. Set insulation quality, sun exposure and climate honestly — they swing the estimate 10–20%.
  3. Count regular occupants (kitchens add load too).
  4. Press Calculate for the BTU/h and kW estimate — treat it as a shopping range, then confirm with a professional for whole-home systems.

How the calculation works

Rule-of-thumb load estimation: base 150 BTU/h per m² per 2.7 m ceiling (scaling linearly with height), insulation factor ×0.9 good / ×1.0 average / ×1.15 poor, sun ×0.9 shaded / ×1.0 average / ×1.1 sunny, climate ×0.95 cool / ×1.0 temperate / ×1.1 hot, plus 600 BTU/h per occupant beyond the second. kW = BTU/h × 0.00029307. These rules trace to common manufacturer sizing guides (≈ 500–700 BTU/m²) — real loads also depend on glazing, orientation, infiltration and internal gains.

Example questions

  • “20 m² bedroom, average insulation, sunny, 2 people”
  • “Open office 60 m², poor insulation, 8 occupants, hot climate”
  • “Living room 35 m² with kitchen opening, shaded, good insulation”

Prefer doing it yourself? These dedicated calculators run the same verified formulas.

Questions you type are sent to the configured AI provider only to extract parameters; they are not stored. Results are computed locally by deterministic engines and are not advice.

Command Palette

Search for a command to run...