Skip to main content

AI Electrical Load Calculator

Describe your loads (“lighting 400 W, fridge 150 W, AC 1500 W, water heater 3000 W”). The calculator sums the connected load, applies your demand factor, and converts to current using I = P ÷ V for single-phase or I = P ÷ (√3 × V × PF) for three-phase. This is a preliminary planning estimate — final circuit sizing must follow the applicable electrical code (NEC/IEC and local amendments) with a qualified electrician.

Ask in plain words

The AI reads your question and fills in the parameters; a verified calculator engine does every calculation.

How to use the AI Electrical Load Calculator

  1. List each appliance with its wattage (check the nameplate).
  2. Enter your supply voltage and whether the system is single- or three-phase.
  3. Set a power factor (motors ≈ 0.8) and optionally a demand factor below 100%.
  4. Press Calculate — then verify the final circuit against your local electrical code.

How the calculation works

Connected load = Σ nameplate watts. Demand load = connected load × demand factor. Current: single-phase I = P ÷ V; three-phase I = P ÷ (√3 × V × PF). Results are preliminary planning numbers — code-compliant design must additionally account for continuous-load factors (125%), conductor ampacity tables, bundling, temperature and local regulations.

Example questions

  • “Lighting 400W, fridge 150W, AC 1500W, heater 3000W on 230V single phase”
  • “Workshop: saw 1800, compressor 1200, dust extractor 750 — 3 phase 400V PF 0.85”
  • “Total load for lighting 600, TV 120, router 20, microwave 1000 at 120V”

Prefer doing it yourself? These dedicated calculators run the same verified formulas.

Questions you type are sent to the configured AI provider only to extract parameters; they are not stored. Results are computed locally by deterministic engines and are not advice.

Command Palette

Search for a command to run...